||Ingersoll Rand CMM (Built in Canada). Net weight (less drill rods) 9,600 Lbs, 4,355 Kg. Height, (tower vertical) 11 Ft, 4 In, 3.45 Meters/Mast laying down 6 Ft, 2 In, 1.88 Meters Overall width, 4 ft, 7 In, 1.40 meters. Drill spindle 3 1/2 API, with smaller API sub attached - Normal drill rod size's, 3 In to 4 1/2. Normal bit size's, 4 to 6 3/4 Inch diameter, (Button DHD). Drill rod length, 5 foot. Hydraulic pipe wrench for break out. Rotary head torque 2000 Foot Lbs with floating spindle. Feed system pull capacity, 10,000 Lbs Tower angle tilt plus or minus 15 degrees. 2 hydraulic motors, rotary head. All controls grouped together. Air and water swivel, with flow control at console. Inline air lubricator 3 Cylinder Deutz Diesel on board to move and position drill. 6 Cylinder Deutz Diesel power pack to run drilling operation in skid mounted module, with hydraulic pump, cooler, air compressor. Connected by hydraulic hose's with quick disconnect fittings. Both engines have catalytic convertors (scrubbers) to clean exhaust.